AXLETECH DRIVESHAFT ADAPTER, 1710 CROSS CUT STRAP made from a high grade

made from a high grade T1 steel they are extremely strong and will not fatigue and crack like factory knuckles

* Note these are installed and held in place with a press fit and can be removed by pounding them out with a long drift from the other side of the axle tube or with a blind hole puller and slide hammer

Nick Jellyman

19 Spline 38-5/8" F106

AXLETECH DRIVESHAFT ADAPTER, 1710 CROSS CUT STRAP made from a high gradeThis 1710 yoke will bolt directly to any narrow Axletech 4000 or T 600 transfer case with the cross cut pattern yokes, allowing you to easily adapt a common 1710 5 Ton surplus drive shaft to your driveline! No need for an adapter between your pinion yoke and U joint flange adapter!